Ambassador 125E Front Loading Autoclave by Rodwell Scientific Instruments

CYCLE PARAMETERS

• Timer: 0 to 119 minutes
• Temperature control from chamber: 100 to 137 deg.C.
• Maximum design pressure: 2.62 Bar (38 psig)

  CONTROL SYSTEM

  • MP 24 control offers up to 24 pre-set programs and many cycle options and features
  • Pressure Gauge
  • Air Removal by upward steam displacement via free steam valve and automatic steam trap.

    SITE REQUIREMENTS
    
    

    • Electrically Heated
    • Electricity supply: 380/415volt, three phase, 50/60Hz rated @ 15 amps per phase.
    • Other Voltages available on request.
    • Drain Service: > 32mm metal drain preferred but not essential if condense collector is specified. Drain service should be no higher than 100mm from floor level.

      SAFETY
      
      

      • Thermal lock to prevent the chamber from being opened if the chamber or load is above 80 deg.C.
      • Pressure lock to prevent the chamber from being opened if the chamber is above 0.04 bar.
      • If either lock fails the autoclave will ‘fault’ in a safe conditions and ‘lock fault’ will be indicated on the control panel and an alarm will sound.
      • Safety devices prevent the cycle being initiated until both door bolts and the outer door lock has been closed.
      • The vessel is designed in accordance with the general requirements of BS2646 Part 1 1993 and EN61010-2-41 1996.
      • All control circuits are 24 volts.

        CONSTRUCTION
        
        The chambers and doors are constructed from stainless steel (BS1501-321 S31 where specified). The outer door is a G.R.P. moulding, which considerably reduces surface temperature. Sealing of chamber is effected by a silicone rubber "O" ring system. Closure is by means of 2 door bolts fitted with heat resistant handles, which are interlocked with the steam release vent. One door bolt is fitted with a captive bolt device to safely reduce any residual pressure for each chamber. Mounted on castors for ease of movement.